/vr/ - Retro Games

>>8376570
Check your PVM's manual and that it takes at least 5V sync voltage, then it will be fine like that.
If it shows only 0.3V, you should put 1k resistors on both H and V sync lines before they go into the Y jointer/splitter.

If you can't solder, you can just get 2 of each of pic related, put 1k resistor between the clamps of the signal terminals and a normal wire between the ground ones. Then put them on the Y splitter before you connect the sync lines. Sync lines don't care that much about shielding, won't make a difference in quality. Shouldn't cost you more than 10 bucks together with the resistors.