[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/diy/ - Do It Yourself

View post   
File: 7 KB, 1152x648, Untitled.png [View same] [iqdb] [saucenao] [google]
1483141 No.1483141 [Reply] [Original]

Anyone else upgraded their firmware to find gaps between the lines of your 3d prints?

Seems to be a nozzle width issue, but its set to .4 like my nozzle?

>> No.1483451

well try setting it to 0.3 dumdum

>> No.1483479

>>1483451
yeah but you can't do that apparently. its bad

>> No.1483491

Filament size set to 3mm but using 1.75?

>> No.1483977

>>1483491
Yeah, I had that once, I think Cura defaults to 3mm. Not OP btw.

>> No.1484085

>>1483491
Its a 4mm nozzle. when set to 0.3 in software it misses parts, and 4mm has the gaps.

Its even changed to 0.4 in the printer settings

>> No.1484139

>>1484085
>4mm nozzle
I dont think that exists. Post pics.

>> No.1484528

Uhm check in your settings under control -> filament if 'e in mm3' is turned on.. if so turn it off.. had that problem too after an update

>> No.1484544

>>1484085
>.4 to big
>.3 to small
hmm i wonder what goldielocks would do...