/diy/ - Do It Yourself

Well, it warped and stick. I decided to continue along with the print to test if measurements are mostly right. Trying to think what I did wrong

I printed something the same thing before and it didn't have such problems. But it was a different filament and larger layer height. Maybe those had an affect

My house is pretty cold, so maybe 60C plate temp is too low? Does it matter? Maybe it was hotter before, I can't remember

For next print should I
>check leveling again
>add a brim
>increase bed temp (it is 60C, is 65C fine? 70?)
>possibly larger layer height, I don't really need thin layers (printed with 0.1mm. I think it was 0.2). Does this really have an affect thou?
>all of the above

It is weird even dpad hole has the issue. So I will probably need brim for inside holes as well

Also I hate how visible those lines at surface are. I am using glass surface and that was bottom. Ironing is better but in that case I need to flip it and waste time and filament for supports