/diy/ - Do It Yourself

>>2635429
>see nothing odd or of note here aside from you extruding your outside walls much faster than the interior, which is the opposite of normal.
Whoops, I swapped those by accident then, wanted faster walls with good-ish looks
>Check your extruder gear and tension
How exactly do I do that?
>clean out the hobbed gear/feeder, make sure there's no debris preventing it from gripping.
I just did that a few days ago to see if that was the problem. Was pristine. I'll take another look when I finish my other duties
>You running a Sprite or Sprite Pro?
Sprite Pro, but with a Bi-Metal heatbreak (old heater block died, bi-metal replacement was almost the same price)
>Your print there is going for up to 8^3mm/s, which isn't a lot really
That's what I thought as well
>but with PETG in a Creality hotend it might be pushing it.
How so, if you don't mind me asking?
>Do a cold-pull in case of debris/partial clog
There's none, I even swapped out the nozzle just today (got a few spares)
>then try the print again at a considerably lower speed
Will try, just doing my homework for uni first, deadline is in a few hours lole
>Given your current settings, I'd say try 30mm/s inside and out, see if it keeps up or produces the same result.
Yessir, thank you a lot Anon!

>>2555203
>No proper signal termination
Got it. The closest analogue I have an in-depth understanding about are RS485-end-nodes without terminator-resistors.

I'm gonna fuck around and find out anyways, but thanks for the info Anon! I'll report if anyone's interested.

>>1628821
I have no faith in get-this-horrible-awful-evil-material-out-of-this-industry fads. There are plenty of examples of substitutes being worse in different ways.