/diy/ - Do It Yourself

>>1706362

3/4 EMT with set screw connectors >clearly not for power colleges want compression for power maybe some shit data/telecom

short piece of uni-strut that will only accommodate one piece of pipe maybe two if you cut the screws on the clamp >not planning or extending the uni-strut up to accommodating both runs of pipe and more for future.

mounting the uni-strut to avoid offsetting the pipe off the wall but cutting the metal studs later down the bend anyway> look ma i can bend a 90 i have mastered all of the pipe bending.

using what looks like a 4ft piece of pipe that a fish tape all in> cuz there is strap and set screw connectors don't hold pipe firmly by themselves.

Grand summery get back to holding the ladder to appease the dick safety boomer who solely exists to make every one else look bad cuz his is only slightly more useless than you. > i wont even mention the unnecessary twisted kick 90 in the corner

>>1660944

>>1606618

if you are looking for technique I have never seen anyone come close to this woman

take notes here

>>1593511
> Im a student of electrical engineering

Then do your own project

Pic related, it's OP