/diy/ - Do It Yourself

WHY THE FUCK ARENT MY MITRES SQUARE ON THE BOX I MADE I CHECKED THE ANGLE BEFORE I CUT AND WHEN IM DRY FITTING ITS ALL FUCKED AHHHHHHHHHH. ALL THE PIECES ARE THE EXACT LENGTH. FUCK YOU MITRE SAW

>make breadboard circuit
>30ish components
>ok lets go to perfboard/make a pcb
>either misolder something or design something wrong in the pcb in ways that would be too much trouble to repair
Did you suck ass when you were starting in electronics? I sure do

Scope anon here. The seller `forgot` to tell me it`s a 110v device and the backplate told me it was 220/110v but I later discovered it was either a 220v or a 110v device. (I`m not that fucking retarded it`s literaly written 220v use fuse 0.5A, 110V use fuse 0.something). So after plugging in 220v mains it went arabic, I replaced the assploded PSU parts, it turns on now, get a trace (a fucking ball) but it doesn`t move and after a while smokes comes out of the HV side. Into the trash it goes. Dumbest mistake and purchase of my life. I think I`ll off myself because someone studying EE doing this deserves no mercy
>>1493284
>>1493284
Yes,but all Minipa stuff is copied from china. This is a kiksui something 20Mhz shitter.
>>1493224
Checked, it`s working. It`s shaped like that.