/diy/ - Do It Yourself

Trying to print this, 2 parallel surfaces and one connecting piece at about a 7-8 degree angle between them. They are offset about 20mm right now but I might need to increase that to 25 or 30mm if this doesn't fit. When I tried to print it flat with one end flat on the build plate and the other elevated 20mm, my printer shit out spaghetti everywhere so it failed and I printed it sideways instead, but it took an hour when printing it flat, it was halfway done in about 7-8 minutes.

I've only been designing parts for 3 days, is there some better way to orient this where it doesn't either take an hour for a prototype piece or poop itself trying to print like I did before? I'm using tinkercad to design and Cura to slice. Printing on a Sovol SV06.