/diy/ - Do It Yourself

>>2621416
Thanks for the Info
>Again, if this "fixes" it, then the real problem is in your config
It did not fix it but it stopped printing a purge line. I also tried printing with a -1.85mm offset on Z, the left part is immaculate, the right half is bad again.

>I assume you're using Bilinear mesh leveling?
I'm using Unified Bed Leveling
#define AUTO_BED_LEVELING_UBL
Also
#define RESTORE_LEVELING_AFTER_G28
is set. Might this fuck with M420 S1?
>G29 S1 will set the movement rate between probing points to 1mm/s, it will not start an ABL sequence.
Ah! So I use G29 without any parameters to create a mesh as usual?

>You're doing some absolute extrusions there in your startup gcode.
Alright
>Check your slicer settings and be sure you're not using relative extrusions, if it's not calling M82/M83 when it should be then you've found a problem.
It does not use relative extrusions, pic related
>If you're not sure or don't know what you're looking at, share the whole gcode file in a pastebin or some shit.
You mean the bed level gcode, right? Sorry, am ESL and 'tistic.
https://pastebin.com/qgHYeZS7