/diy/ - Do It Yourself

>>2767535
Oh it was cleaned. I'm not that naive.

>>2767542
In my experience the clip-on dust catchers shed bits of foam, and that foam gums everything up.

>>2767545
Theres a bunch of considerations for printing threads, but probably the most obvious is
1) thin layers ie: 0.1mm, 0.04mm
2) space between the male and the female threads. 0.4mm is usually good (0.2 on both sides), if you specify 0.4mm line widths in your slicer rather than allowing the defaults which in some cases are 0.45 or similar