/diy/ - Do It Yourself

>>2773134
>Is that a DFN-8?
this one is 8-SOIC, but I do have a few fine pitched components on the back side I still need to populate. I will be using PCBA so no worries about hand soldering.

I have imported the fab house design rules into Altium and am leaving a conservative amount of clearances.

I just feel like I'm bound to mess something up and this whole thing is stressful. I wish it didn't have to be this small but the whole board is only 30x30mm driven by my client's requirements.

Anyways, thanks for the pointers. I'll add some ground fill on the top layer like you advised.

pic related is my progress so far. All this aligning is really triggering my OCD and I keep redoing it a million times.