/diy/ - Do It Yourself

>>2630160
yeah, the V6 heat break nozzle combination is around 2-3mm shorter than the stock kingroon setup, I tried adding a spacer which got me really close to the stock nozzle position, test print looked like shit I was able to drop nozzle temp by 20 degrees, I think my ABS filament is wet, the stock kingroon setup seems to be a lot more forgiving of wet filament, I think the filament is drying as it enters that long narrow heat break and the moisture is escaping the top of the heat sink. While in the V6 setup the filament is cold until it reaches the heat block and the moisture can only escape out the nozzle.

I cut another V5 heatsink but this one is 3mm longer to put the nozzle tip as close to the stock location as possible, the other option is to cut volcano nozzles down.