/diy/ - Do It Yourself

>>2761790
I decided to print something bigger to see if maybe the part was just too thin, and it printed no problem. No warping or surface issues that would be inherent to the filament and not settings. The only issue is a slight layer misalignment from me being an ape and grabbing a separate printed item without pausing the rest of the print.
So I guess I need to either dry my nylon more, or this particular spool just doesn't like small/thin prints. Going to try drying it more, as I did a test print of the wire guard when it was fresh out of the box and it came out fine with no warping or anything. So its probably just a little wet.
Was also worried about the supports possibly being a problem with nylon, but it snapped off just fine.