[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/diy/ - Do It Yourself

Search:


View post   

>> No.2762500 [View]
File: 95 KB, 1599x899, untitled.jpg [View same] [iqdb] [saucenao] [google]
2762500

BAnon here. I'm doing a (paid, but almost at cost) job at 0.6mm line width and 0.3 line height with an 0.4 nozzle. I was getting underextrusion in the first layer but increasing the flow by 15% from Octoprint without resetting the print got it printing just right. It's a bit chunky in the corners as I haven't yet enabled linear advance (sue me) but it works and the lines are nice and [ T H I C C ] and buttery smooth. Maybe I'll try 0.8 lines and 0.4 layers next.
>inb4
<v6 hotend
<bimetal heatbreak
<vanilla bedslinger on vanilla wheels
<2019 firmware. yes, i said i'd update it or replace the board, i'll get to it
<updatedish octopi

Navigation
View posts[+24][+48][+96]