/diy/ - Do It Yourself

printing a cirno for /bant/
have printed multi part and sanded models before, but this detail size is a bit higher with small hair strands and wings.

I need a way of connecting 3mm posts with rough ends (I assume sand and super glue from the sides) and recommendations on what to use after a sanding from a 2-in-1 primer, spray can or hand painting ( I use cheap house paint samples, if this route what type)

also what is the best method in printing long, small posts for outer quality, printing across the z axis causes melting of the post and ugly outside texture to the point where I had to change cooling to directly on the nozzle.