/diy/ - Do It Yourself

>>2760795
If your skirt doesnt look to be the same height as your specified layer height, it's a nozzle height issue.
Try printing a skirt 2 or 3 lines wide and then measuring it.
You can do it after the print completes if its not too bad.
Or you can snip it so it doesnt catch the nozzle and then just rip it up to measure, albeit it wont be as accurate after youve hot-stretched it a bit.
Or you can just cancel the print after the skirt completes, wait 10 minutes and then pull up a solidified skirt to measure.
Generally you should be able to tell if the nozzle level is out of whack by whack by watching the skirt get printed.
I like to do one of these after I bed mesh, for fine tuning nozzle height.