/diy/ - Do It Yourself

>>1328792
Yes, it gets a lot of traffic on there.

https://www.thingiverse.com/thing:2376150

>>1328931
>is the Monoprice MP Select Mini any good for miniatures?
Sure. It's just slow and small. The v1 is a pain in the dick for a few reasons. The v2 extruder is much better.

Just reroute the heated bed wires and add some PEI. I made a front-facing filament holder for all three of mine due to space constraints.

Also, the included SD cards will corrupt over time. If your prints start to layer shift just pull the card, format it, then reload all your gcode onto it.