/diy/ - Do It Yourself

>>2586936
Also this happened. It printed supports and walls just fine and then tried printing ceiling/front but it failed to attach near button holes.

I think my printer is under extruding so it was not able to stitch those bits. I had similar issues before as well, sometimes it is not able to connect walls and wall lines together and leaves small gaps, even while printing directly on top of the plate

And perhaps it was a bit too hot? I dropped temp when I see that and increased flow rate to 105-107% and it went fine after that. It was able to recover on following layers. But I might have bumped flow rate a bit too high because there are some weird patches at front, although nothing was "spewing"

I will check my z-step calibration, I never did that before. Sounds like that might be the cause