/diy/ - Do It Yourself

Installed the new CURA and my supports on the red pumpkin were like iron. I had to beat it with a chisel in the garage and wound up splitting the body.

Is it the material? PLA and I've had trouble with layer adhesion, which should be the opposite problem obv. But is there a setting that would affect the supports being welded in place? The gray smaller pumpkins also have too much support adhesion esp. near the base with different settings which could be the model, the new CURA version or my imagination. The gray is my standard PLA go to for everything.

So... what should I try to make supports easier and cleaner with the red PLA?