/diy/ - Do It Yourself

Anonymous Fri Apr 24 19:56:14 2020 No.1805462 [View]
File: 357 KB, 1493x1080, bridge and overhang.jpg [View same] [iqdb] [saucenao] [google]

Ran a bridge & overhang test. Ender 3d, Cura, PLA, 200°, 16s layer time, stock fan at 90% with some simple duct. I dunno what other settings are relevant.

the 30mm bridge has some sagging but looks quite good imo. the overhang is acceptable to around 70°, I usually set overhang support to 72° anyway, so I think I'll leave it there depending on the print.

Anything else I could do to improve this? Should I up the fan max speed to 100%? Increase layer time? go straight to dual 5015?

File from some youtuber who was comparing Bullseye and Hero Me.
>https://www.youtube.com/watch?v=xPvLKSClShc

After seeing all the results, I'm not sold on the value of printing these super complex and heavier cooling solutions.

>>1805414
awesome, good to know.

Advanced search
Text to find
Subject [?]Search by post subject. Leave empty for any.
Username [?]Search for user name. Leave empty for any user name.
Tripcode [?]Search for tripcode. Leave empty for any.
Email [?]Search by email. Leave empty for any.
Filename [?]Search by image filename. Leave empty for any.
From Date [?]Enter what date to start searching from. Format is YYYY-MM-DD
To Date [?]Enter what date to start searching until. Format is YYYY-MM-DD
Image hash
Search in	All Posts OPs Only
Deleted posts	Show all posts Show only deleted posts Only show non-deleted posts
Internal posts	Show all posts Show only internal posts Show only archived posts
Order	New posts first Old posts first
Capcode	All Posts Only by Users Only by Mods Only by Admins Only by Developers
Results	Posts Threads
Action	[ Simple ]

Navigation
View posts	[+24]	[+48]	[+96]

/diy/ - Do It Yourself

Search: