/diy/ - Do It Yourself

No idea where to post this, but there should be a couple of good Fusion users here. I'm trying to simulate the impact of an airgun pellet onto a 8mm sheet of polycarbonate and then using the model to reduce sheet thickness to determine the minimum.
I've tested this in real life and the bullet does not penetrate, but in Fusion, there's a hole in the panel and several bullet shards on the other end of the panel once the simulation is done. What could be going wrong here?
>Materials are working properly
>Panel and pellet are properly fixed
>Tried different mesh settings, still got penetration
>Time window is set properly