/diy/ - Do It Yourself

>>1297772
I've used Hatchbox and Makergeeks. So far, most impressed with Makergeeks hot pla (235° print temp) as it makes it easier to switch between PLA and ABS and I've gotten decent prints out of it. I haven't tried PETG yet, but I have >4 kg from makergeeks that I'm about to start doing test prints with this week.

I've got a fang fan shroud and a z support brace. So far I haven't had any reason to upgrade any other parts. I am considering upgrading/adding dampers to my motors. If I'm printing circles and all the motors are going at once I can hear in my room from across the hall even with the door shut. I was given quieter fan for psu that I haven't installed yet, but was told it makes a big difference on the noise level*

>friend also has CR10, but has a kid he doesn't want to wake up when its sleeping. He's done all the quieting upgrades and says it makes a huge difference.