/diy/ - Do It Yourself

>>1942319
Here's an example of a dovetail I used. Just cut the part in two with a parallelogram profile, chamfered the edges of the fat part of the dovetail and the outer edges of the hole, then press/pulled the angled dovetail faces back 0.05mm. I can push the parts together by hand, but need a hammer to dislodge it, because the thin edges hurt my fingees and due to the geometry you can't get good purchase on it without locking up the joint even more. You might have to increase the clearance if your printer is shit. Got the chamfer and press/pull thing from this cunt: https://youtu.be/bPcoza4gIxM