[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/diy/ - Do It Yourself


View post   

>> No.2811443 [View]
File: 59 KB, 800x600, 11368695922.jpg [View same] [iqdb] [saucenao] [google]

So I got a laser cuter . Sadly I live in a very old house which was damaged by water at the groundlevel and also the workers at that time were pretty drunk I guess so the whole floor in the whole house isnt level . I mean at all .
Every room has different pitches . If you place a ball in the middle of the rooms it rolls in different directions depending in which room you place it.

The cutter needs a even surface to work properly ,so how do I get a even surface ?
I tried to align the table without any good results ( its just to big I guess ) . Is mounting a walltable a easier solution ? I cant be bothered to renew the whole floor .
some ideas ?

View posts[+24][+48][+96]