/diy/ - Do It Yourself

>>1845368
> is this direct drive?
No, it's bowden.

> what does the filament look like? is the filament being ground down and thus unable to be pushed through?
Pic is of last 4 attempts at printing. Filament seems to be ground down and the extruder can't get a good grip.

> have you tried tightening the tension arm on the extruder?
I've loosened it. I would have expected tightening it would exacerbate the issue.

> any knots in your filament/do you have a difference brand to test with?
No nots. Unfortunately I only have 1 brand (Overture) in a few different colors.