/diy/ - Do It Yourself

I finally got around to printing the rest of the Mostly Printed CNC parts. I posted a few of my completed parts months ago when I was piecing the hardware together.

I finally put it together today.
Fit it all together, made sure its square and leveled.
Hooked it up to my laptop, got it moving on every axis correctly.

First thing I do?
Unplug it from laptop, and then start working the X and Y axis by hand to wear the bearings and rails in and smooth them out.
Steppers were still plugged into the ramps so I immediately burnt up the Arduino...

So thats nice, its going to sit till the middle of next week when I get my new arduino.