/diy/ - Do It Yourself

>>1272936

Ah i see, you must have an Ultimaker-style printer with a "cantilever bed" configuration. In my case it's a Mendelmax 1.5 printer where the X-axis is suppored on both sides by the Z-leadscrews and linear rods. Adding any more leadscrews isn't an option there, and most of the wobble really comes through as a rocking motion in the direction shown in red in my picture. I have a good idea on how to remedy that though.

Since you're using integrated leadscrew motors - how much do they wobble? They're supposed to be perfectly centered from the factory, but sometimes get bent during shipping. There's even this video describing how to replace them if that's the case:

https://www.youtube.com/watch?v=NmmFoBsSfEQ