[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/diy/ - Do It Yourself

Search:


View post   

>> No.1341078 [View]
File: 266 KB, 2048x1536, gantry.jpg [View same] [iqdb] [saucenao] [google]
1341078

The plates are here

It turns out that even with the linear rail carriages bolted down by the 4 holes I can still twist the gantry a bit around its Z axis, so it's possible I may change it to a Corexy afterall. I'm printing a dummy carriage with proper belt attachment to see if the racking effect will actually be noticeable. If it is, I'll make idler holders for 4 bearings instead of two each, lower the rear gantry idlers using aluminum spacers and end up with a non-intersecting corexy machine that is at least much more solid than my current one and capable of better detail due to direct extruder

Navigation
View posts[+24][+48][+96]