/diy/ - Do It Yourself

Buildtak bed levelled, axes checked, bed cleaned, nozzle cleaned , new filament roll, same settings I've been running.

I've found out that this happens almost always on long linear extrusions for base layers - shorter 1cm travel is usually fine. Layer wall/filling is fine, just base layer is having problems like this. Extruder is clean, nozzle degunked.

50mm/s, PLA at 200C, bed at 60. I haven't been racking my head enough for this. Is this adhesion or extrusion problems? What the hell is going on with my bed.

I need to start making Christmas gifts but I can't due to autism with bed layers.