/diy/ - Do It Yourself

>>2763122
>That corner is probably the seam and the cutout has the slicer move the seam somewhere else. Most likely in a place where the time spent not extruding is smaller.
Yeah it's the seam. And I see the same thing happening on the printed part where other seams are.
In pic related, on the outer wall seam, there's a section at the bottom where the seam is narrower, which printed properly.

>Are there any other spots on the print where this shows? Maybe not outright gaps but walls that are visibly thinner than they should be?
The walls are very consistent aside from these seam gaps.