[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/diy/ - Do It Yourself

Search:


View post   

>> No.2761790 [View]
File: 183 KB, 1368x1133, Technically successful cf nylon prints.jpg [View same] [iqdb] [saucenao] [google]
2761790

Retard that's been struggling with printing nylon.
Have a semi successful print done, and I'm pretty sure the problem was me leaving the zipper on the enclosure open a little too long during the start just in case they immediately failed so I could cancel as they all curled on the side facing the opening. But they stuck well enough to finish.
The prints aren't the cleanest, but getting a successful first print is the first step, then tweaking other settings to get cleaner prints.
Then on to doing larger prints. My hope is that if I get small stuff to print right first, the larger ones will have less issues.

Navigation
View posts[+24][+48][+96]