/diy/ - Do It Yourself

I posted this in the /3dpg/ few months ago, but you fags seem like you might appreciate a repost. I designed and 3d printed these brackets so I could stack 2 HDDs on top of each other in the same slot. I was a bit nervous about mounting hardware with some shitty pieces of plastic I made. But it turned out stronger than I expected, even with the design flaws. Part of me really wants to try to design and print an entire PC case from scratch. But at the same time it seems like a bad idea to build a case out of just plastic that can easily warp and crack from heat. what do you guys think?

I made a hard drive sandwich. I'm halfway considering trying to print an entire pc case now