/diy/ - Do It Yourself

$*$*$*$*$**$*$****** SEX ROBOT CONECPT VIDEOS**%**$*#*@*!@#(!@*#!
butt stuff conecpt that is
******************
http://youtu.be/cQrJUZ0a_9g

>>>>>>>>>>>____ http://youtu.be/SuPkIOtWp1w _____<<<<<<<
>>>>>SEX ROBOT CONECPT VIDEOS<<<<<
http://youtu.be/8ePsSbc-1v0

^^^^^^^^^****** FANCY NEW STROKING TECHNIQUES********^^^^^^

******* THIS VIDEO SHOWS OFF MY FANCY AS FUCK NEW TOOL CENTER POINT***
LIKE THE POINT IS ON THERE WITH GLUE AND IT CANT EXCAPE*****
https://youtu.be/X5duDTPzBGI
****************************************************
ok, I found a suspect wire. spliced in a new section where it looked bad and booted her up.

She worked for a little bit, then i had to keep jiggling. there is a section of wire that was A LOT harder/stiffer than any other section, this section of the wire was the part not covered by parts of the robot, like one the outside section of the robot. I jiggled that section and shes going good again. I think somewhere in that stiff section is where its fucked because the wires in the strain relief part all look good now after the one was replaced.

Last weekend I set up a tool point center and made the new bracket for the saw, but could not test because wire was fucking up too much.

This week I re origined all my axis using the alignment marks on the robot. She is now moving in sexy ways around the tip of tool and I can finally get it to move proper in straight lines about the tool.