[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/diy/ - Do It Yourself

Search:

View post   
>> No.2519089 [View]
File: 308 KB, 1920x1080, set-of-bolts-and-nuts-3d-printable-3d-model-stl-blend.jpg [View same] [iqdb] [saucenao] [google]
2519089

>>2518535
Yes. M500
https://marlinfw.org/docs/features/eeprom.html

>>2518295
PLA+ won't matter vs PLA for heat resistance. Either would be fine up to at least 230F after annealing. HTPLA will warp at least 5x less during the anneal. Just slowly ramp up the heat in hot water during the anneal, bonus if you pack in sand or plaster prior. It won't melt when hot but it will get softer, kinda like when you steam wood so you can bend it.

>>2518263
superslicer/prusaslicer IIRC should do like 120% flow on the first layer. Just keep your plate clean with alcohol before every print. Some prints are just hard to get good adhesion and need a brim. If your cooling is shit you'll end up with curling which will snag the nozzle.

Navigation
View posts[+24][+48][+96]