/diy/ - Do It Yourself

>>1406560
I'm using KiCad/Pcbnew, there's a "show vias in fill mode" which makes them look like this, if that's what you mean?

>>1406567
Yeah I used the default 0.25mm trace/0.60mm via width and I was just thinking that bigger would probably be better; I'm inferring from >>1405140 that it doesn't cost any more to have wider traces. Thanks for the advice - I mostly manually routed it, but I did take some of the suggestions from the software. As a result there are fewer traces on the board than in the schematic, but I have to admit it does make it harder to understand so I might ignore it completely and try to mimic the schematic more closely.

Can anyone recommend any good places to get the board printed? I'm in the U.K. if that makes any difference.