/diy/ - Do It Yourself

For image at top, I want it to retract before jumping these holes so it does not cause strings. I think it is not retracting because it is going over the model anyway and any leakage will be stuck under the layer it will print later. But I want it to retract anyway. Am I missing a setting?

I am searching produced gcode for "retract" or "E-" but there is no retraction other than the ones at the beginning and the end.

For comparison on bottom, it does retract before jumps. See the gcode, E-3.52105 after it draws "outer wall" for left cube

here are the gcodes if someone wants to confirm or deny

top image
https://pastebin.com/JTnBBWKF

bottom image
https://pastebin.com/KVyKTWJN