/diy/ - Do It Yourself

>>2498719
I guess I would have 2 different motor drivers with the dir and power signals individualized. Just the pulses, my microcontroller only has two outputs capable of highspeed pulses so I wanted to use just one for the gantry table.

>just use a couple of NAND or NOR gates to switch which driver the step signal goes to
How would this look like on a PLC? This might be a dumb question, but can I have a single 24vdc output controlling this relay coil and changing the direction of output for the pulses? Would this affect the pulses at all?

For example, stepper 1 would be NC, stepper 2 would be NO. Or are there better alternatives