/diy/ - Do It Yourself

>>1575889
>1.2 to 3.2mm layer height
>On a 0.8mm nozzle
Upper limit for layer height is 80% of your nozzle size, so 0.64mm. 1.2 is way too big, nevermind 3.2. However, your problem is in the Y axis which means it's skipping steps at that exact point or the G-code is broken. Reslice on a different Y bed position and it'll probably be fine.

>>1576105
>You need an enclosure.
What is this, amateur hour? Crank up your heated bed to 90-100 degrees and it's usually fine. Print a bit slower than usual, no fans, and use plenty of adhesive/hairspray/acetone-ABS slurry to keep it planted.