/diy/ - Do It Yourself

>>1488446
You have those wired as a 4 ohm circuit and you're connecting them to an amplifier that is rated between 6 and 16 ohms. Not going to be good for the amp.

If you're going to run three of those 8 ohm speakers, wiring them all in parallel makes the ohms too low (2.7 ohms) and wiring them all in series makes the ohms too high (24 ohms).

The receiver has two sets of stereo outputs (labelled "front A" and "front B") that can be run at the same time. Connect each of the three speakers to one of those stereo outputs individually.

You could do some weird shit like wire 2 in parallel and 1 in series on the same circuit, but there's no point when the amp has enough channels to run each individually.