/diy/ - Do It Yourself

>>1995666
>At some point, you’re fucking wrist is going to give out.
This, I used to have an 18v 1.5 Ah battery powered brushed Makita drill that I used to start my racing mower but then when I tried it in winter I broke my wrist from the drill and after I got a cast I tried it again and got it started but broke the drill. Then I asked on this very board if I should buy the same drill or the 'new improved brushless' version and this very fa**ot the canadian who accounts for 90% of the posts on this board told me 'oh get the brushless version its harder duty working more torwque for starting your racing mower and lo and behold this thing is a piece of shit with a 5Ah battery it wont even ream out a 1" tube like my old makita and it wont screw more than 7" deep and fuck i wish I never listend to the advice i got off this shithole or at least the fucking asshole that told me that.

>>1872677
this. I did it on a 1 1/4" copper radiator joint 3 years ago, still holding strong knock on wood.

>>1871933
It all worked out for me, I can't complain. Call that hubris if you must.

>>1730333
to be fair, that would have been a perfectly acceptable bench design had it been made out of metal.

>>1722722
>nominal pipe size supposed to be somewhere between ID and OD
pretty sure its always a little bit more than actual ID in case your viscosity and/or corrosion buildup is high, it still flows pretty good like its supposed to.

>>1691677
>>1690995
>>1691037
It's too early to be this drunk, Anon.

>>1670888
>why are the simplest solutions to problems always so damn hard to figure out
Idk but everything I've learned so far in life I've learned while taking a piss.

>>1642122
>i was planning to fuck a real hot escort
you should probably do it anyways. It'll be a night you'll both remember forever.

>>1624311
what in the literal fuck

>>1586199
thanks, you think soffit vents + gable vents is sufficient? Any need for a ridge vent?

>>1544733
dubs of truth, what can I say

>>1490855
ok I think you need one of these with a 26 on one end (welder) and a 17 on the other (torch): https://www.airgas.com/product/Welding-Products/Welding-Support-Equipment/TIG-Torch-Parts/p/RAD64005962

>>1486966
>>1486929
we use S-traps on bathroom sinks here in freedomland and even some kitchen sinks, syrup-boy.

>>1484877
fucking ten volt light faggot

>>1480733
I was just fucking with you but then you made me feel bad so I actually looked it up: https://www.aliexpress.com/store/product/10sets-2Pin-2-0MM-car-speaker-connector-Auto-horn-plug-voltage-regulator-connector-for-buick-Honda/229762_32311787923.html

>>1478133
>>1477952
This, make it into a knife: https://www.youtube.com/watch?v=IvPbQdbsQUI

>>1474088
>1 hour with a chainsaw and I dropped said branches and I got another guy to drop the rest of the tree for $75.
why didn't you just drop the tree yourself?

>>1473341
who is this mono-pole di-hole?

>>1470633
>>1470661
wow no holes in the table, that's a good start.

>>1469600
wew laddie

>>1440048
and all without needing to (((log-in)))
>>1440044
every try buying anything off grainger or MSC?

>>1437633
>ten-thousands
>tenths

>>1434455
beautiful

>>1431988
>side grain visible, not concave chirping the vertical
3.5/10