/diy/ - Do It Yourself

>>2690033
Here's a pic of the Ender 3 setup with some mods. And here are the print parameters that I used for the print. If there is anything glaringly wrong or missing hopefully a kind anon will point it out
>Layer height: 0.12
>Wall count: 4
>Infill: cubic, 30%
>Print temp: 210 C
>Bed temp: 60 C
>Print speed: 50
>Travel speed: 175
>Initial layer print speed: 20
>Initial layer travel speed: 80
>Support: tree, touching build plate
>Material used: ePLA
>Nozzle: 0.4mm
Some things I'm considering are a slower print with a 0.2mm nozzle. I'll probably do stiffer bed springs because I'm running stock springs that give bed wobble. For the layer shifts im gonna clean the z screw properly and lube it for the first time in its long life

Been thinking about an enclosure to help my petg prints, not sure if it will help this print