/diy/ - Do It Yourself

Little update on the TPE jellyfish. One side I've printed on 50mm/s for the most part and ~75mm/s for finishing it off because I had to leave, and that turned out fine in my black filament. Throwing a flat 75mm/s on white filament for another side resulted in these lines, which made it really weak, much weaker than it's opposing side. Rather frustrating. I swapped because I was running low on filament, but I guess I'll find out about it soon when I print it again in black. Attempting 70mm/s on black and seeing if it does the same pattern again.

Beginning to have bad thoughts on my clamping design. Looks like I'll be slapping teflon tape at its seams.

If it all fucks up again I'll suck it up, get more filament and eat the 16 hour print times on 50mm/s.

Frustrated, annoyed. Aiming to get results by Wednesday.