/diy/ - Do It Yourself

>>1944408
>the biggest chunk of time was actually disabling the "enable support brim" tick which makes the printer do a full first layer at low speeds, 25mm/s in my case
>i wouldnt print it like that except it would be a throwaway prototype, if you want it to look nice print slower and in the orientation of this anon >>1944392
Yep. Fully agreed. But in this case I didn't care since it's on a printer and don't mind the looks. It's black too so it's hard to see detail.
>next question would be how much this thing obstructs the airflow, the stock fan is already on its limits cooling-wise, i wouldnt cover it up and risk heatcreep, maybe do some 3h test prints to see if it happens
I'm printing a Benchy with it on right now. 1:30min+ left. I'll post pics. We'll see if it fucks up prints.
>>1944360
>Not that dude but instead of printing that hot garbage you should print a reverse cooling duct.
>It's a tad bit quieter than the stock fan and it doesn't blow air on your prints.
>https://www.thingiverse.com/thing:3419531
Never seen this one before. Thanks anon. I've been looking at that Petfang thing but it looks so damn complex and it looks like it requires an extra fan or something too. Just don't wanna waste my time with it if it doesn't work well.
Also came across Hero Me 5 thing... have no strong opinion on it either.