/diy/ - Do It Yourself

>>1182356
I used a couple sawhorses and a piece of old plywood as my table. You want a couple feet of space on one side, where you can lay your fiberglass sheet.

The axle is 1" steel pipe from one of my longer pipe clamps, and it is held up using some garage hooks I had. To lock rotation for indexing, I just used a spring clip.

I prepared my work area as if I was disposing a body. You don't want a single drop of this epoxy to land where you dont want it. Have every tool laid out and ready to go, and have a garbage can ready because you are going to toss about half a dozen pairs of epoxy soaked gloves during this process and you don't want them to get glued to your shoes and tracked around. I even had my disposable scrubs ready to go with a box of gloves. YOU WILL GET IT ON YOUR SHIRT AND PANTS.