/diy/ - Do It Yourself

ryobi user summed up perfectly in one picture

dump them in the ocean

find your fuse block

pull fuses one by one until radio turns off when connected to shore power

install toggle switch in that circuit

or just remove the radio because that shits annoying as fuck anyway

a table with grooves

your tools sit on a piece of whatever that has a shape that matches the groove

slide em in slide em out

or

fuckin magnets

or

just fucking drill holes guy

>workbench
>cant drill a hole

wat

forgot to add, always spin the hose first to break it free from the mating surface, makes like a lot easier. they kinda get stuck if ya know what i mean

yea you fucked up

use 2 hoseclamps instead of whatever lump of shit youre calling a clamp on there

when doing hose of basically any sort, if theres a clamp involved, two of them are almost certainly better than one

ever since i started using two - no more leaks or split at the clamp

ex:
shop air @ 135 psi
oxy/ace lines
fuel lines

take the drain plug out

drill it to 21/64

tap it to 1/8 npt

install a 1/8 npt plug with some thread tape or sealant of some
sort

install drain bolt assembly with some rtv/red loctite/aviation gasket maker/weld/jb weld/silicone/thread tape/hammer it in/silly putty

preferably throw a quick weld along the old drain plug where it meets the pan since it will be fairly thick there with the bung and all

then to do your oil change next time take a 9/16 wrench spin out the 1/8 pipe plug drain the oil put the plug back in and roberts your mothers brother

mail it to me i need a spare mobo to test my shit

think my mobos toastered but i want to be sure before i spend the money on a new motherboard

tried everything else including testing the psu so im out of ideas

>>1464894

probably dog piss

also thats a breather/vent just pull it out and forget about it

unless you can figure out how to use google and find where it belongs

>>1463836

theyre called handheld flamenwerfers

>>1463491

this actually made me laugh thank you

dude get a cordless angle grinder and a couple zipcuts and just the bolts it would cost like 130 bucks and take 20 mins

dont waste your time with a corded impact inverter and a solar set up lol

what the actual fuck

weld it you fucking nigger

the catch is you have to pay for it, its called a land line

no its not cheaper than electricity the usual way

hammer a small torx bit in there, or drill it out

or if its not important looks like side cutters could get you where you need to be

not sure but you better scrub it off and repaint it one foot to the left and rotated 90 degrees

what are you unsure of exactly

theres pins, bushings, grease reliefs in the bushings

pin goes in bushing

connects 2 pieces of shit together to form one more useful piece of shit

like your knee or your elbow

you know what assholes, im joining the ranks of the tripfags

not that anybody cares, im just a jerkoff anyways

oh but im actually a real heavy duty mechanic/welder that uses my tools instead of buying them and coating them in wd-40 and saran wrap

i have no opinion on bepis or kevin but that may change for better or worse

cya gays around, have a nice trip cya next faggot