/cgl/ - Cosplay & EGL

>>6476977
One bicep exterior is complete. Made from 1mm sintra sandwiched at certain points for strength.

Im using a two-part expoy to bond panels from the inside this time around rather than super glue and hot glue. It should be stronger and I can sand it to a smooth edge if I let it seap through the cracks where panels meet first.

Waiting a few hours for the epoxy to set completely before moving on the the next bicep. Still need to cut a path for my arm and a place for the padding to make my shoulders appear wider.

I upped the scale again very slightly since I thought the mockup for the shoulder still looked a bit small.

Here is the mostly complete bicep next to the original paper mockup.