/3/ - 3DCG

>>491772
It's a custom mesh insert brush I made in max. this is documented but if you hold down shift in the middle of an insert mesh curve brush drag and drag outside of the mesh, it will try to make a loop around it. Then the usual moving around with move brush and and inflate in deformation window to make it look thicker

If you get jaggies with the insert mesh curve brush, I've included the settings screen in the Brush window as well. It took me two hours of tutorials to hunt down the right attribute to increase the number of steps in the spline without decreasing the increment of the actual mesh sections: Curve Res. The ZClassroom videos on insert mesh brushes are very thorough and you should watch them, though.

Hope that saves you some time, anon.